Lash Packs - Topaz

Please note bond and seal and eyelash remover is sold seperatly or as part of our DIY kit.

Before applying any of our lashes we recommend you patch test our bond 24 hours prior to application, if irritation/reaction occurs discontinue use. 

Make sure your eyelashes are free from any make up or oil based product, and are clean and dry.

Application

Step 1

Brush the 'bond' from our bond and seal onto your natural eyelashes, starting from the root ( take care not to get any bond into your eye or on your lash line) brush upwards. Once the bond is applied wait 10-20 seconds for the bond to go tacky.

Step 2

Using your applicator tool(make sure this is clean and free from any bond and seal) gently peel your lash cluster off the tray, hold the cluster as close to the band at the bottom as possible to avoid any damage to the cluster, dab some bond on the root and band of the cluster, we recommend working from your outer lashes inwards. Place the cluster underneath your natural lashes as close to the root as possible. Repeat this step until you have your desired full lash look.

Step 4

Apply the 'seal' from our bond and seal, you can either brush it on using the brush or dab using the sponge on the end of the brush. Only apply the seal to the areas the bond has been applied- try not to get the seal on the end of the lash clusters as it can make the lashes stick together and lose their fluffy effect.

Step 5

Using your applicator tool (make sure this is clean and free from any bond and seal), clamp your lashes together to lock them into place. Clamp at the root aswell as half way up your lashes.

Tips for keeping your lashes secure for as long as possible

• After application keep your eyelashes away from water and steam for 24 hours.
• Use your applicator tool to clamp your lashes everyday, if any of your clusters become a little lose this will clamp them back down into place and hold them in for longer.

Removal

Step 1

Close your eye, generously brush the remover onto your lashes starting from the root and brush down- focus on where you applied the bond and seal.

Step 2

Wait 20-30 seconds for the remover to loosen the adhesive. Use a cotton pad or a wipe to gently wipe away the lashes and adhesive. Repeat until your natural lashes are free from bond residue.

Step 3

Use the remover on your eyelash clusters to remove the bond so you can re use them, do this by brushing the remover through your cluster and gently peel any bond off the band using your fingers. Use cleansing water to clean them once all the bond has been removed. once dry pop them back into your tray to be reused.